wiring components BG2.5.10
- Design fork
- Length 210 mm
- large cross-section (10 mm²), high rated current of 63 A
Details
Busbar for DRCBO 4 type B/B+, fork, 2-pole, 10 mm², 12 MW (module width), 63 A
These components for the wiring of circuit breakers in industrial, commercial and privately used electrical distribution units significantly reduce the installation work. The cut-to-length busbars of the Eurovario system lend themselves to the supply-side connection of residual current circuit-breakers with integral overcurrent protection combinations DRCBO 4 B+ and B on the underside of the device. The rails have a fork design and are available with two and four poles. The EV-S BS contact protector does not cover connections used.
Eurovario system phase bar in forked design with a fixed number of module widths, these rails are not suitable for cutting to length
The rails are inserted in the lower terminals of the devices to be connected.
Busbars from this series are used for residual current circuit-breakers with overcurrent protection (RCCB/MCB combination) of the series DRCBO 4 type B and B+ in power supplies to residential and purpose-built buildings as well as to industrial facilities.
The rated current specification is by no means decisive for the planning of a low-voltage installation, as the busbar heats up depending on the current level. Planning must be carried out by a qualified electrical specialist or planner and must comply with the applicable installation regulations. Protection against direct contact is only ensured when touch-protection caps are used for unused terminals.
Busbar for DRCBO 4 type B/B+, fork, 2-pole, 10 mm², 12 MW (module width), 63 A
These components for the wiring of circuit breakers in industrial, commercial and privately used electrical distribution units significantly reduce the installation work. The cut-to-length busbars of the Eurovario system lend themselves to the supply-side connection of residual current circuit-breakers with integral overcurrent protection combinations DRCBO 4 B+ and B on the underside of the device. The rails have a fork design and are available with two and four poles. The EV-S BS contact protector does not cover connections used.
Eurovario system phase bar in forked design with a fixed number of module widths, these rails are not suitable for cutting to length
The rails are inserted in the lower terminals of the devices to be connected.
Busbars from this series are used for residual current circuit-breakers with overcurrent protection (RCCB/MCB combination) of the series DRCBO 4 type B and B+ in power supplies to residential and purpose-built buildings as well as to industrial facilities.
The rated current specification is by no means decisive for the planning of a low-voltage installation, as the busbar heats up depending on the current level. Planning must be carried out by a qualified electrical specialist or planner and must comply with the applicable installation regulations. Protection against direct contact is only ensured when touch-protection caps are used for unused terminals.
Supplies
